• Servo Systems Co.

Applied Motion Products Si2035


The Si2035 is a programmable stepper drive/indexer packaged in a rugged steel case. Integral heat sink, mounting brackets, and mating connectors are included with each drive. The Si2035 is recommended for use with NEMA 11, 14, 17, and 23 frame motors and comes with all operating software necessary to create a complete stepper motion solution. The Si2035 includes our Si Programmer™ software for quick set up and easy programming. Si programming is ideal for stand-alone operation. For more experienced users with software development expertise, the Si2035 also operates in SCL mode, which permits controlling the drive and motor by streaming serial commands from a host PC or PLC, thus allowing the user to command all drive functions from the host software application.

Multiple axis applications are handled by our SiNet™ Hub multi-axis controllers and the SiNet Hub Programmer™ software application, which give users the ability to control up to 8 drives from a single program. You can also use our MMI operator interface to allow machine operators to enter specific motion parameters. Factory set for 110 VAC operation, the Si2035 can be set by the user for 220 VAC operation with a single switch. Pluggable screw terminal blocks are provided for motor and AC power connections. A 25-pin D-Sub connector is provided for digital I/O connections. Mating connectors, programming cable, and software are provided with each drive.

Features include:

  • Si Programmer™ compatible indexer/drive
  • AC input 110V or 220V switch selectable, 50-60 Hz
  • DC bus voltage 28 VDC full load, 35 VDC nominal
  • Software selectable motor current from 0.2-2.0 amps/phase
  • Software selectable microstep resolution and idle current reduction
  • Eight optically isolated digital inputs
  • Four optically isolated digital outputs
  • RS-232 for PC/MMI communications
  • D-Sub and pluggable screw terminal connectors
  • Dual H-bridge, pulse width modulated amplifier switching at 20-30 kHz
  • Ideal for 4, 6 or 8 leaded step motors NEMA sizes 11, 14, 17 and 23
  • Optional operator interface (MMI) allows users to enter specific motion parameters
  • SCL mode for streaming serial commands from host controller

For more information visit our support center


Part Number 5000-110
Supply Voltage 110/220 VAC
Supply Voltage Type AC
Control Modes •Streaming Commands
•Si Programming
•SiNet Hub Compatible
Output Current 0.2-2.0 A/phase
Communication Ports RS-232
Encoder Feedback No
Step Resolution Microstepping
Idle Current Reduction 0, 25, 50 or 100%
Setup Method Software setup
Digital Inputs 8
Digital Outputs 4
Analog Inputs 1 (supported by SCL only)
Dimensions 6.8 x 4.0 x 1.75 inches
Weight NA
Operating Temperature Range 0 to 70 °C
Ambient Temperature Range 0 to 50 °C
Ambient Humidity 90% max, non-condensing
Status LEDs 1 red/green (power/status)
Circuit Protection NA