• Servo Systems Co.
Home/Products by Manufacturer /Applied Motion Products/ STM23S-xxx Integrated Drive+Motor w/Q Programming & Encoder

Applied Motion Products STM23S-xxx Integrated Drive+Motor w/Q Programming & Encoder

STM23S-xxx Integrated Drive+Motor w/Q Programming & Encoder

The STM23Q integrated stepper is a drive+motor unit, fusing a NEMA 23 step motor and a sophisticated 5.0 A/phase (peak-of-sine) stepper drive into a single device. Power to the drive, located at the rear of the motor, must be supplied by an external DC supply. This integrated stepper can operate in all of the same control modes as the S option, plus the ability to run a Q program stored in non-volatile memory. Q programs are created using Applied Motion’s Q Programmer™ software, which provides powerful commands for motion, I/O, conditional processing, multi-tasking, math functions, and more. All STM23 units are setup and configured using Applied Motion’s ST Configurator™ software.


An integral 1000-line (4000 count/rev) incremental encoder is housed inside the same enclosure as the drive electronics, providing protection from dust and debris. The integration of the encoder means the STM23Q-2AE can perform special functions not available otherwise. Stall Detection notifies the system as soon as the required torque is too great for the motor, which results in a loss of synchronization between the rotor and stator, also known as stalling. Stall Prevention actually prevents stalling of the step motor by dynamically adjusting motor speed to maintain synchronization of the rotor to the stator under all conditions. This unique feature allows step motors to operate in a much broader range of applications than previously available to step motors, such as torque-control applications. The Stall Prevention feature also performs static position maintenance, which maintains the position of the motor shaft when at rest.


Each STM23 integrated stepper comes with 3 digital inputs, 1 digital output, and 1 analog input. The digital inputs accept signals of 5-24 VDC and can be used for connecting pulse & direction signals, end-of-travel limit switches, jog switches, quadrature encoder signals, PLC outputs, sensors, or many other signal types. The digital output can be connected to PLC inputs, counters, lights, relays, or other devices. The analog input accepts 0-5 VDC signals and can be used for velocity and position control.


The STM23Q-2AE and STM23Q-3AE comes with an RS-232 port for programming and serial communications. The STM23Q-2RE and STM23Q-3RE comes with an RS-485 port for programming and serial communications.


Features include:

  • Sophisticated current control
  • Anti-resonance
  • Torque ripple smoothing
  • Microstep emulation
  • Q programming mode for stand-alone control
  • Capable of all “S” control modes
  • Built-in incremental encoder

For more information visit our support center


SPECIFICATIONS

Part Number Frame Size Supply Voltage Control Mode Holding Torque (oz-in) Communication Ports Encoder Feedback
STM23Q-2AE NEMA 23 12-70 VDC Streaming Commands
Analog Positioning
Encoder Following
Q Programming
SiNet Hub Compatible
125 RS-232 Yes
STM23Q-2RE NEMA 23 12-70 VDC Streaming Commands
Analog Positioning
Encoder Following
Q Programming
125 RS-485 Yes
STM23Q-3AE NEMA 23 12-70 VDC Streaming Commands
Analog Positioning
Encoder Following
Q Programming
SiNet Hub Compatible
210 RS-232 Yes
STM23Q-3RE NEMA 23 12-70 VDC Streaming Commands
Analog Positioning
Encoder Following
Q Programming
210 RS-485 Yes