Home/Products by Manufacturer /Applied Motion Products/ STM24x-xxx Integrated CANopen Drive+Motor

Applied Motion Products STM24x-xxx Integrated CANopen Drive+Motor

STM24x-xxx Integrated CANopen Drive+Motor

The STM24C-3CN integrated stepper is a drive+motor unit, fusing a NEMA 24 step motor and a sophisticated, 6.0 A/phase (peak-of-sine) step motor drive into a single device. Power to the drive, located at the rear of the motor, must be supplied by an external DC supply. This integrated stepper is designed to operate on a CANopen communication network and conforms to Can in Automation (CiA) DS301 and DSP402 specifications. It supports Profile Position, Profile Velocity, and Homing modes, as well as the ability to run stored Q programs via Applied Motion-specific CANopen objects. All STM24 integrated steppers are setup and configured using Applied Motion’s ST Configurator™ software.


The STM24C-3CN comes with 3 digital inputs and 1 digital output. The digital inputs accept signals of 5-24 VDC and can be used for connecting end-of-travel limit switches, jog switches, quadrature encoder signals, PLC outputs, sensors, or many other signal types. The digital output can be connected to PLC inputs, counters, lights, relays, or other devices. The unit also comes with 1 analog input that accepts 0-5 VDC signals, which can be used for velocity and position control.


The STM24C-3CN comes with an RS-232 port for programming and a CANopen port for network communications.


Features include:

  • Sophisticated current control
  • Anti-resonance
  • Torque ripple smoothing
  • Microstep emulation
  • DS301 and DSP402 supported
  • Profile position and velocity modes
  • Several homing modes
  • Objects for Q programming
  • Objects for data registers
  • RS-232 port for programming

For more information visit our support center


SPECIFICATIONS

Part Number Frame Size Supply Voltage Control Mode Holding Torque (oz-in) Communication Ports Encoder Feedback
STM24C-3CN NEMA 24 12-70 VDC CANopen 340 RS-232
CANopen
No